2U RACKMOUNT/ ESR-212

The ESR series Storage server balances what the End-User and System vendor needs to deliver the best solution, provides classy design, highest flexibility, easy to install and maintain, more storage in limited space and ultimate drive and data protection in this limited space. The ESR-212 has up to six hot-swappable cooling fans and with multiple temperature sensors at the hot points that has been tested and approved by intel to support Nocona/Irwindale Processor up to 3.6Ghz. The ESR-212 redundant, load-sharing power supply modules and power management circuitry accommodate the dynamic requirements of today’s drives. ESR-212 further includes power supply-to-drive isolation, which allows control over voltage and current fluctuations

Features and Benefits

Supports SSI EEB 3.5, CEB 1.1 or AMD Dual Opteron compliant server boards
Power MOSFET and pre-charge circuit for surge current protection on hard drive and backplane
Horizontal backplane design to allow maximum airflow for system cooling
Included SGS approved slide rail
3 years warranty on power supply
Other High Quality Components are backed by life time warranty

Specification

Dimensions

3.5"(H) x 19"(W) x 28"(D)

Front Access Connector

Front Access switch

ower On/Off, Reset, Alarm Reset

Front Panel Indicators

Power On, HDD Activity, PSU failure, Fan failure, Over heat warning, LANs

Hot swap drive indicators

Power On, HDD Activity, HDD failure

Power Supply

550W 1+1 Hot-swap redundant power suppl

Power Supply Options

460W Fixed, 600W Fixed

System Board

Up to 12x13 E-ATX, ATX, EEB 3.5, CEB 1.1 compliant

Drive Bay

Internal slim 2.5" x 1 ( 4 maximum )

Hotswap Bay x 12

Data Backplane

Serial ATA PTP

Serial ATA Multilane

Ultra 320 SCA

Serial Attached SCSI

Included Data cable

Yes

Included slide rail

Yes

System Monitoring

Fan / over heat / power supply fault detection

Thermal

Intel Validated Pass Xeon 3.6Ghz 800Mhz

SATA backplane Specification

1. A power MOSfET to provide disk spin-up control 2. A pre-charge circuit for surge current protection when a disk is plugged in to protect the hard-disk drive and the backplane. 3. LED: Blue ON = HDD present; Blue Blanking = Drive activity; Red=Drive failed 4. A 4x2 header for Drive activity and Drive failed LED signal input 5. A 4x3 jumper with 4 jumper cap is added to select either disk activity LED is provide by the Host Bus Adapter or form HDD such as Western Digital or axtor Diamond Max X hard disk drive 6. Single DC input to provide better cable management 7. SATA data connector with latch to secure the SATA cable is not loose 8. Options included Point-to-Point or Multilane data cable connection. 32pin 4-lane-to-1-lane connection available (special order only)

SCSI backplane Specification

Technical Documentation

Technical Borchure

ESR-212.pdf

User Manual

ESR-212_manual_rev_1.pdf